English >> Audi V8 Forum Previous   Index   Next   Flat   Threaded

S. Reged: 14/02/2010 Posts: 1 3.6 automatic transmission problem       07/05/2010 15:39 Edit   Reply   I have been fighting with this problem for a long time now. Problem is the transmission and car is not moving at all, gear lights did work. I got blink codes 2134,2131,3221 only once, after that TCU went offline totally, all gear lights are on. I did get new TCU because I tought that the original went bad. Anyway now it work this way: Gear is in N-position, turn the key power ON, you can move the stick to every other gears and lights on dash do work, but, when you put it on R-position, TCU go OFF again and all gear signal lights go ON. TCU won't star after battery cable is off for few minutes, only when I switch other TCU on and put gear on N, D, 1 or 2 position gear shifting works again, until I put it again to R and TCU goes OFF. One day is was able to move car on R-gear two times, then it died, D-gear did not work. I have cleaned all 4 connectors on transmission. Could this problem be inside on valve body or R-solenoid? How you measure the solenoids? Post Extras

Entire thread Subject Posted by Posted on 3.6 automatic transmission problem S Antero 07/05/2010 15:39 Re: 3.6 automatic transmission problem Roy F   14/06/2011 22:05 Re: 3.6 automatic transmission problem diligti MKD   14/06/2011 02:40

UBB.threads™ 6.1

Generated in 0.038 seconds in which 0.036 seconds were spent on a total of 14 queries. Zlib compression enabled.