SQL ERROR: Database error only visible to forum administrators
Exhaust Hanger Replacement Made Easy - www.AudiV8.com - Audi V8 Forum / Audi A8 Forum
Das neue Audi V8 Forum findest Du hier!
www.v8forum.de

SQL ERROR: Database error only visible to forum administrators
English >> Talk

a.

Reged: 07/03/2013
Posts: 12
Exhaust Hanger Replacement Made Easy
      15/03/2013 07:23


A broken exhaust hanger can be bad news.
If you've been hearing an extra clunk underneath the car, or if it looks like a sparkler at night thanks to a dangling muffler, you might have a broken exhaust hanger. Most exhaust hangers (aka muffler straps) are just thick rubber loops, kind of like really strong rubber bands. Like anything rubber, exhaust hangers eventually wear out, and that's when your muffler starts to suffer.
The best way to figure out if you have a broken exhaust hanger is to take a peek under the car. Follow the exhaust pipe to the muffler. You'll see at least one black rubber exhaust hanger close by. If it's broken, you'll see right away. Be sure to check for other exhaust hangers, as well.

"Hang" the exhaust hanger on the top mount.
Once you've located the broken exhaust hanger, remove the old one from both the top mount and the muffler. It might be in two pieces, so be sure to get all of the old exhaust hanger out of there.
Now you can start to install the new exhaust hanger. Begin by hanging it on the top exhaust mount, the one attached to the car. Just let it dangle there while you prepare for the next step.

If you have a helper, get him or her to hold the muffler in place while you attach it to the exhaust hanger. If not, don't sweat it, you can slip the muffler mount into the hanger while you hold up the muffler. That's where this muffler repair trick comes in.
For a one-handed exhaust hanger installation, grab a Crescent wrench with a hole in the handle. Slide the handle end through the exhaust hanger, then put the hole in the handle on the exhaust mount. Now use the wrench to slide the exhaust hanger over the mount. Now you're hangin' again!

Post Extras Print Post   Remind Me!     Notify Moderator

Entire thread
Subject Posted by Posted on
* Exhaust Hanger Replacement Made Easy arron liu 15/03/2013 07:23

Extra information
0 registered and 0 anonymous users are browsing this forum.





Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is enabled
      UBBCode is enabled

Rating:
Thread views: 3291

Rate this thread
Jump to

Contact Webmaster AudiV8.com

*
UBB.threads™ 6.1

Generated in 0.018 seconds in which 0.014 seconds were spent on a total of 14 queries. Zlib compression enabled.