English >> Audi V8 Forum Previous   Index   Next   Flat   Threaded

N. Reged: 23/09/2012 Posts: 20 Hi Guys, New here!       23/09/2012 18:36 Edit   Reply   Hi Everyone I have just saved a 1992 4.L motor v8 from the crusher. Sadly the car is a wreck. I have built from scratch a Zonda R replica, it was powered by a twin turbo Jag V12 from a 1980 XJS, however I got fed up with spending too much time on the engine and not enough finishing the car. The 1992 Audi V8 turned up yesterday and I set about removing the engine. What a nightmare! In 2 days I have got it stripped down, and ready to take out, just getting the headers off was a real chore What are you supposed to lift the engine with? It doesn't seem to have any lifting hooks Once its out, i will have to do a service, fit a 36-1 trigger wheel to the front pulley, source a flywheel.. Oh well the things we do Cheers Nick Twin turbo Audi V8 Zonda Replica Post Extras

Entire thread Subject Posted by Posted on Hi Guys, New here! Nick Truman 23/09/2012 18:36 Re: Hi Guys, New here! Nick Truman   01/10/2012 11:10 Re: Hi Guys, New here! Nick Truman   13/11/2012 16:03 Re: Hi Guys, New here! Manfred M.   14/11/2012 05:54 Re: Hi Guys, New here! Roy F   23/09/2012 22:28 Re: Hi Guys, New here! Nick Truman   23/09/2012 23:07 Re: Hi Guys, New here! Roy F   24/09/2012 19:39 Re: Hi Guys, New here! Mark Hanman   23/09/2012 19:45 Re: Hi Guys, New here! Nick Truman   25/09/2012 16:22

UBB.threads™ 6.1

Generated in 0.06 seconds in which 0.058 seconds were spent on a total of 14 queries. Zlib compression enabled.