|
|
|||||||
Hi, I wanted to inquire if anyone has attempted to swap the 4.2 motor from a D2 A8 (4.2) into a D11 V8 (4.2) chassis. Is it a direct swap and is there a write-up available. I figure it would be a great way to improve the reliability and performance of the V8 Quattro.. Thanks in Advance.... Des |
||||||||
|
|
|||||||
If you take a look through the Gallery, there's a set of pics of one with an S8 engine. So it's been done. The guys email address is there, too |
||||||||
|
|
|||||||
You will need to relocate one of the side mounts. You are talking about an ABZ engine? |
||||||||
|
|
|||||||
Relocate? That's a drag. It seemed there was enough similarity with the ABH. |
||||||||
|
|
|||||||
What's the engine code? usually they took a AEC into V8 if it has to much oil consumption... |
||||||||
|
|
|||||||
AEC cars are rare in UK. More common over on the continent, I think. Audi A8 4.2 uses ABZ engine. It appears to have a number of external parts in common with ABH/PT. So dimensions wise, it should be straightforward. I was considering getting an ABZ to explore this route. But if we are talking about making engine mounts already, then, I don't know. |
|
Generated in 0.006 seconds in which 0.005 seconds were spent on a total of 4 queries. Zlib compression enabled.